South African Class 6E 4-6-0

This article is about the South African steam locomotive. For the electric locomotive, see South African Class 6E.

OVGS 6th Class L3 4-6-0
CSAR Class 6-L3 4-6-0
South African Class 6E 4-6-0

300px OVGS 6th Class L3, CSAR Class 6-L3, SAR Class 6E

Type and origin ♠ - Original locomotive, as built ♥ - Locomotive rebuilt with Belpaire firebox Power type Steam Designer Cape Government Railways (H.M. Beatty) Builder Sharp, Stewart and Company Serial number 4464-4469 Model CGR 6th Class Build date 1898 Total produced 6

Specifications Configuration 4-6-0 (Tenwheeler) Driver axle 2nd coupled axle Gauge 3 ft 6 in (1,067 mm) Cape gauge Leading dia Coupled dia 54 in (1,372 mm) Tender wheels as built 34 in (864 mm) retyred Wheelbase 46 ft 11 in (14,300 mm)  • Engine  • Leading  • Coupled 11 ft 4 in (3,454 mm)  • Tender 16 ft 1 in (4,902 mm)  • Tender bogie 4 ft 7 in (1,397 mm) Wheel spacing (Assymetrical) 1-2: 4 ft 9 in (1,448 mm) 2-3: 6 ft 3 in (1,905 mm) Length:  • Over couplers Height ♠ 12 ft 10 in (3,912 mm) ♥ Frame type Plate Axle load ♠ ♥  • Leading ♠ ♥  • 1st coupled ♠  • 2nd coupled ♠  • 3rd coupled ♠  • Tender bogie Bogie 1: Bogie 2:  • Tender axle Adhesive weight ♠ ♥ Loco weight ♠ ♥ Tender weight Loco & tender weight ♠ ♥ Tender type XC1 (2-axle bogies) XC, XC1, XD, XE, XE1, XF, XF1, XF2, XJ, XM, XM1, XM2, XM3 permitted Fuel type Coal Fuel capacity 5 LT 10 cwt (5.6 t) Water cap Boiler:  • Pitch ♠ 6 ft 8 in (2,032 mm) ♥ 7 ft (2,134 mm)  • Diameter ♠ 4 ft 4 in (1,321 mm) ♥ 4 ft 9 in (1,448 mm)  • Tube plates ♠♥  • Small tubes ♠ 185: ♥ 220: 2 in (51 mm)  • Firebox type ♠ Round-top - ♥ Belpaire Boiler pressure ♠ 160 psi (1,103 kPa) ♥ 180 psi (1,241 kPa) Safety valve Ramsbottom Firegrate area ♠♥ 16.6 sq ft (1.54 m2) Heating surface ♠ 1,116 sq ft (103.7 m2) ♥ 1,398.5 sq ft (129.92 m2)  • Tubes ♠ 1,015 sq ft (94.3 m2) ♥ 1,287.5 sq ft (119.61 m2)  • Firebox ♠ 101 sq ft (9.4 m2) ♥ 111 sq ft (10.3 m2) Cylinders Two Cylinder size 17 in (432 mm) bore 26 in (660 mm) stroke Valve gear Stephenson Couplers Bell link-and-pin

Performance figures Tractive effort ♠ 16,690 lbf (74.2 kN) @ 75% ♥ 18,780 lbf (83.5 kN) @ 75%

Career Operators OVGS Imperial Military Railways Central South African Railways South African Railways Class OVGS & IMR 6th Class L3 CSAR Class 6-L3 SAR Class 6E Number in class 6 Numbers OVGS 96-98, IMR 370-372, CSAR 333-335 & 370-372, SAR 598-603 Delivered 1898 First run 1898

The South African Railways Class 6E 4-6-0 of 1898 was a steam locomotive from the pre-Union era in the Orange Free State.

In 1898, the Oranje-Vrijstaat Gouwerment-Spoorwegen ordered its final six new Cape 6th Class locomotives. When British forces invaded the Orange Free State during the Second Boer War, these locomotives were taken over by the Imperial Military Railways. After the war they were renumbered into the Central South African Railways roster. In 1912, when they were assimilated into the South African Railways, they were renumbered and designated Class 6E.

Manufacturer

The original 6th Class 4-6-0 passenger steam locomotive was designed at the Salt River works of the Cape Government Railways (CGR) at the same time as the 7th Class, both according to the specifications of Michael Stephens, then the Chief Locomotive Superintendent of the CGR, and under the supervision of H.M. Beatty, then the Locomotive Superintendent of the Cape Western System.

File:H.M. Beatty.jpg

H.M. Beatty

The first ten 6th Class L locomotives of the Oranje-Vrijstaat Gouwerment-Spoorwegen (OVGS) were purchased second-hand from the CGR. These were followed by orders for twenty-four new 6th Class L2 locomotives, directly from the manufacturers, which were delivered between 1895 and 1898.

A final order for six more locomotives was placed with Sharp, Stewart and Company in 1898. Three of these engines, designated 6th Class L3, had been delivered and numbered in the range from 96 to 98 on the OVGS roster, when British forces invaded the Orange Free State during the Second Boer War and the OVGS was taken over by the Imperial Military Railways (IMR). When the other three locomotives arrived, they were therefore numbered in the range from 370 to 372 on the IMR roster.

These six locomotives were delivered with larger cabs than their predecessors and with Type XC1 bogie-wheeled tenders. The first three engines retained their OVGS numbers until the war ended in 1902, when they were renumbered into the Central South African Railways (CSAR) roster. The other three locomotives retained their IMR running numbers on the CSAR and all six were designated CSAR Class 6-L3.

Class 6 sub-classes

When the Union of South Africa was established on 31 May 1910, the three Colonial government railways (CGR, Natal Government Railways and CSAR) were united under a single administration to control and administer the railways, ports and harbours of the Union. Although the South African Railways and Harbours came into existence in 1910, the actual classification and renumbering of all the rolling stock of the three constituent railways required careful planning and was only implemented with effect from 1 January 1912.

When these six locomotives were assimilated into the South African Railways (SAR) in 1912, they were designated Class 6E and renumbered in the range from 598 to 603. These engines, together with the CGR's fleet of 6th Class locomotives and the Class 6-L1 and 6-L2 locomotives which had been inherited by the CSAR from the OVGS via the IMR, were grouped into altogether fourteen sub-classes by the SAR. The 4-6-0 locomotives became SAR Classes 6, 6A to 6H and 6J to 6L, the 2-6-2 locomotives became Class 6Y and the 2-6-4 locomotives became Class 6Z.

Modifications

P.A. Hyde, the Chief Locomotive Superintendent of the CSAR from 1902 to 1904, considered the 6th Class as "about the best design for their weight ever made". Several of the Class 6-L1 to 6-L3 locomotives were modified by Hyde by having their round-topped fireboxes replaced with larger boilers and Belpaire fireboxes. This conversion improved their performance tremendously, to the extent that they could be used in place of the 8th Class, where they were formerly outclassed by load. This represented an increase in hauling capacity of some 12%, while their coal consumption was reduced by some 5%. The three Class 6E locomotives which were renumbered in the SAR range from 601 to 603, had undergone this modification.

During the 1930s, many of them were modified once again, when the Chief Mechanical Engineer of the SAR at the time, A.G. Watson, embarked on his program of standardisation and reboilered them with round-topped fireboxes again, but without changing their classification.

Renumberings

The Class 6E locomotives were renumbered twice, first from the OVGS and IMR rosters onto the CSAR roster and, in 1912, onto the SAR roster. The table lists these renumberings, as well as their builder's works numbers.

Class 6E 4-6-0
Works numbers and renumbering

Works no.	OVGS no.	IMR no.	CSAR no.	SAR no.
4464	96		333	601
4465	97		334	598
4466	98		335	599
4467		370	370	600
4468		371	371	602
4469		372	372	603